Device Hardware Check

Question

Do you have any device health check qapps? If not, how about this idea: check device hardware with various commands, e.g. Cisco's show module, show environment

show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
4 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX x
5 5 Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G x

Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
4 f 4.2 8.4(1) 15.5(1)SY8 Ok
5 d 1.3 12.2(50r)SYS 15.5(1)SY8 MajFail

Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
5 Policy Feature Card 4 VS-F6K-PFC4 SAL16159W6L 1.2 MajFail
5 CPU Daughterboard VS-F6K-MSFC5 SAL16159EYD 1.4 MajFail

Mod Online Diag Status
---- -------------------
1 Pass
2 Pass
3 Pass
4 Pass
5 Major Error

Page 1 / 1

Hello Carsten,

Yes, its a good idea to use “show module” or “show environment”. Use/create parser to parse key values from these output. Then create Qapp based on your requirement. You can also use DVT which is lightweight if you just want to visualize the parser variables as device table or as a device note.

Thanks,

Pradeep

Reply

pradeep.gaddameedi · Answer

HelloCarsten,Yes, its a good idea to use “show module” or “show environment”. Use/create parser to parse key values from these output. Then create Qapp based on your requirement. You can also use DVT which is lightweight if you just want to visualize the parser variables as device table or as a device note.Thanks,Pradeep

Reply

Sign up

Sign in with SSO

Login to the community

Sign in with SSO

Scanning file for viruses.

This file cannot be downloaded