Hi @Al78  Thanks for your post.

To compare the Configuration and Route table, could you try the Change Analysis feature, please refer to https://www.netbraintech.com/docs/ie80/help/index.html?change-analysis.htm. Unfortunately, It does not support alert.

As for the CLI commands, may add the commands to the System Benchmark and compare them manually.  See below:

Hi @Al78  Did the above solution work for you?  Anything we can help with?

Hello, 

I went to the https://www.netbraintech.com/docs/ie80/help/index.html?configure-ca-settings.htm

Now I am trying it out to see what that looks like.

I am going to try and automate the manual process you mentioned as well.

I have just checked the “change analysis report” and found something strange. It says there were changes to a switch config:

interface VLAN 100----->interface unrouted VLAN 100

I assume this is saying that the interfaces originally had layer 3 connecttivyt/IP-SVI but does not have it anymore.

I logged into the switches to double check and this was not the case. Do you know what could cause this reporitng error?

@Al78  It compares the two configurations retrieved at a different time. If the original configurations are truly different in the interface configuration:  interface VLAN 100 & interface unrouted VLAN 100, it will show the changes.  Could you check the original configuration files.