Parser for NXOS Radius Groups

I was able to get what I needed.   Although I would still like alternate methods.  

I used a paragraph parser for a CLI command and not the Config.   

Command: show radius-server

ID Line Pattern: 

regex[$string:radSvr]:(\d+.\d+.\d+.\d+):

This regex matched the IP address only, follow by colon.   

Rest simple variables.    

I just wonder if there is an easier way to pull repeating lines out like in the example in OP.   With 2 servers in the group.  

MyStupidSwitch-1#show radius-server

Global Radius shared secret:********
timeout value:5
retransmission count:1
deadtime value:0
source interface:any available
total number of servers:2

following RADIUS servers are configured:
    10.2.3.4:
        available for authentication on port: 1812
        available for accounting on port: 1813
        Radius shared secret:********
        timeout:5
        retries:1
    10.2.3.5:
        available for authentication on port: 1812
        available for accounting on port: 1813
        Radius shared secret:********
        timeout:5
        retries:1
 

Thank you very much.   I will try that shortly and report back.  

Worked perfectly!   Thanks again