Question

Device Hardware Check

  • 16 December 2021
  • 1 reply
  • 152 views

Userlevel 4
Badge +1

Do you have any device health check qapps? If not, how about this idea: check device hardware with various commands, e.g. Cisco's show module, show environment

show module
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  4   48  48-port 10/100/1000 RJ45 EtherModule   WS-X6148A-GE-TX    x
  5    5  Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G       x

Mod MAC addresses                       Hw    Fw           Sw           Status
--- ---------------------------------- ------ ------------ ------------ -------
  4                                 f   4.2   8.4(1)       15.5(1)SY8   Ok
  5                                 d   1.3   12.2(50r)SYS 15.5(1)SY8   MajFail

Mod  Sub-Module                  Model              Serial       Hw     Status 
---- --------------------------- ------------------ ----------- ------- -------
  5  Policy Feature Card 4       VS-F6K-PFC4        SAL16159W6L  1.2    MajFail
  5  CPU Daughterboard           VS-F6K-MSFC5       SAL16159EYD  1.4    MajFail

Mod  Online Diag Status 
---- -------------------
  1  Pass
  2  Pass
  3  Pass
  4  Pass
  5  Major Error


1 reply

Userlevel 2
Badge

Hello Carsten,

Yes, its a good idea to use “show module” or “show environment”. Use/create parser to parse key values from these output. Then create Qapp based on your requirement. You can also use DVT which is lightweight if you just want to visualize the parser variables as device table or as a device note. 

 

Thanks,

Pradeep

Reply


Community |  Ideas

Facebook |  Instagram |  Youtube |  Twitter |  LinkedIn
Privacy & Security Statement  |  Terms & Conditions |  Impressum  |  UK Modern Slavery Statement